Two-sided pendant with Celtic ornament

1. Materials:
- Dense cloth
- Polyester yarns in the tone of the material or beads
- Needle for beads
- Pins
- Paper (not thick, you can tetrad sheet)
- Beads of choice
- Scissors
- Marker and chalk
- Pencil
- Compass 

2. Preparation of templates.

On paper, compasses hold a circle with a diameter of 5.5 cm inside draw the contours of the future pattern. Cut out a pattern.

3. Attach the pattern to the fabric, pin it with pins and draw a marker or crayon. Cut the contour of the workpiece from the tissue.

4.Primetayte template to zagotovke.Vysheyte pattern outline.

Cloth material rather loose, and zavyazany at the end of the thread bundle can reach out through him, so it is best to fix a thread through the first bead.

Place the beads as tightly as possible to each drugu.Po opportunities do single stitch, the best seam “back with a needle”, so reliable, and the pattern will be smoother.

5.Po end embroidery gently tear off the paper, small pieces, remove the needle.

6.You truncation of the paper pattern will be slightly disrupted, it must be vyrovnyat.Slozhite thread in half, fasten it on the cloth and go through all the lines uzora.Ne pull the thread too much, not to deform the product.

7.Otstupiv from the edge of 3.2 mm, marker mark the circle inside zagotovki.Vysheyte on it a number of border (it is necessary for the plaited loops). Align embroidery as in claim 6.

8.Po request can be sewn beaded design all or some of its parts.

One half of the pendant is ready.
9.Takim same way (paragraphs 3-8) Make the other half of the pendant.

10. Check the fine on both halves of the future top pendant. Fold both sides of the pendant is “back to back.”

Fold the string in half, tuck in a bead needle (to withdraw about 1,5 m lines). Picot stitch sew the two halves of the pendant.

Pico: fix the thread close to the edge of the product.

Bring out the thread on the front surface, departing from the edges of 2-3 mm (depending on the strength of fabric – the stronger the edge, so close to him can sew). String 2 beads on a string, back to the start line about the width of a bead, and bring the needle through the fabric on the front side.Do not pierce the fabric again, thread through the last bead and string it one more bead. Repeat again, slightly retreating from the last bead.

11.Izgotovlyaem petelku.Slozhite thread twice, season with a needle to thread bisera.Otmette 8 beads edging, secure the thread as close as possible to the extreme of them.

Bring out the needle close to the very marked beads, pass into a bead by bead 2 bead type 9, go to the bead 2, type bead 10, go to the bead 4, type the bead 11, go to the bead 6, type the bead 12, go to bead 8 and so on

Thus, the mosaic weave, weave the strip length of 3 cm, humus and its pripletite to the corresponding six-bead edging on the back of the pendant

After plaited loops, fasten the thread from the fabric, as close to the loop, put the needle into the tissue close to the knot and go through the pendant naskvoz.Obrezhte thread close to the surface.

Pendant is ready!

source: s50.radikal.ru