New Post

Popular Post

Keywords: Making flowers

  • Tulips from corrugated paper

    Cutting paper, Making flower, Paper crafts  |  0 Commenttulips from corrugated paper

    Do tulips, paper easiest and faster than the roses and astry.Tehnologiya perform the same as that of roses .For this reason, I'm not just going to refer to the master class for the implementation of roses , in order not to repeat. So, take a small piece of paper: In tulip petals are not very many, I did eight. Next, we add a segment of the paper as well as in roses and asters (permanently joining the ends). Should yield a folded segment of a width of one petal: Cut at one

  • Ball on the Christmas tree of paper flowers

    Holiday & seasonal crafts, Making flower, Origami, Paper crafts, Wrapping and Packaging  |  0 Commentball on the christmas tree of paper flowers

    Original decoration of paper flowers. At first glance it seems that the hack is complicated. However, to make it very simple. To work will need: construction paper, glue, pencil, scissors. Better to take a glue pen, he glues faster and stronger. Shall cut paper squares with a side of 7, see our ball will consist of 12 flowers, each flower out of 5 petals. Total need 60 squares. We have 2 types of flowers. Color combinations you can pick up different, but you can make solid colors. We add the square on

  • Astra corrugated paper

    Cutting paper, Making flower, Paper crafts  |  0 Commentastra corrugated paper

    For a start, I propose the corrugated paper aster. Tools necessary to work: corrugated paper (minimum of two colors), scissors, iron sticks. We cut off about seven inches of corrugated paper. Cut a piece of paper, expand and divide into three parts. Iecut from a piece of paper can be done three flowers. Required us to cut paper jackknife, then again twice and again .... - Until you have a pile of about 4-5 cm in width is very important to exactly add up. Piles on the sides makes an incision about half can

  • Rose of corrugated paper

    Cutting paper, Making flower, Paper crafts  |  0 Commentrose of corrugated paper

    This time try to make a rose out of corrugated paper. Tools are the same as that forcreating asters . Grab a segment of corrugated paper and add as well as for the asters . Cut the edges of the paper, as shown in the figure, more importantly, to the edge still remained connected.Expand the segment of paper should look like this: This is some of our future petals. Begins with each of them to work. Over the long edge of each petal must be rotated (crush and crank): Further work with the other

  • Lumps of corrugated paper

    Cutting paper, Making flower, Paper crafts  |  0 Commentlumps of corrugated paper

    Now let's try to make corrugated paper cones. I usually make in brown or green paper. Seen, however, from the yellow paper, and thought at first that it is corn. Before you do bumps, I advise you learn how to make other flowers: roses , asters , or tulips . More than once I will refer to the manufacture of these colors. Well, let's start. For the manufacture of cones, we need the brown or green crepe paper, scissors, wire and hands. So, we take a segment of the paper length about 30 cm Top

  • Rosettes in the décor

    Making flower, Needle crafts, Sewing  |  0 Commentrosettes in the décor

    1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. 25. 26. 27. 28. 29. 30. 31. 32. 33. 34.

  • Recycling old book: more ideas to making flowers

    Green crafts, Making flower, Paper crafts, Recycle  |  0 Commentrecycling old book: more ideas to making flowers

    1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11.

  • Flowers from vegetables to decorate the holiday table!

    Carving fruit, Other crafts  |  0 Commentflowers from vegetables to decorate the holiday table!

    1. 2. 3. 4. 5. 6. 7. 8.

  • Recycling plastic bottles: Making flowers

    Green crafts, Recycle  |  0 Commentrecycling plastic bottles: making flowers

    You have a withered tree in the garden and uproot sorry ... Do not worry, you can decorate it with flowers from plastic bottles. - What do I need? Bottle, knife, scissors, nail polish and a little patience. - First do-propyl knife sawing. - Then cut the bottle with scissors. That's what we've got: two blanks for the flowers, and one, big - for leaflets. - Cut into the side of the workpiece. My fantasy give me a number of petals. Between them, I cut 'stamens and sepal. The tips of the petals in a fitting