Featured Post

New Post

Popular Post

Fall scarf : sewing patterns

Sewing  |  September 16th 2011  |  0 Comment

Sewing tutorial….
Description:

This tutorial will guide you through the steps to make your own ruffly (cause that is a word, spellchecker even said so) jersey knit scarf that will keep you looking cute and staying warm. It has exposed raw edges and is super comfy around your neck. It can easily be completed from start to finish in a couple of hours, even if you are a beginner!

Materials Needed:
2.5 yd jersey knit (14″x84″piece)
*2.5 yd of 60″ fabric will make 3 scarves*
thread
Pieces to cut from jersey knit fabric:
Cut 2: 7″x70″ pieces for scarf body

Cut 2: 5″x14″ pieces for ruffles

*ensure that greatest degree of stretch is along 5″ side (width wise) rather than 14″ side (lengthwise) for these pieces — or ruffles will be “flat”*

Directions:
1. Using a basting stitch (longest stitch length on your machine), stitch down 14″ side of one 5″x14″ piece, 1/2″ from edge. Leave threads at beginning and end of stitch lines long. Stitch again 1″ from first stitch line. Continue stitching lines 1″ apart across width of fabric. The last stitch line will be 1/2″ from edge, just as the first stitch line. You should have stitched 5 lines total.

2. Cut in between each set of two stitch lines, forming 5 strips 1″x14″.
3. Pin one strip to right side of one 7″x70″ piece as pictured. One end of strip will be along edge of long piece 8″ from the bottom, and other end will match up with bottom of long piece.
4. Pin middle of strip 4″ from bottom of long piece.
5. Pulling on TOP threads only, gather one end of strip up to the middle pin. Repeat with other end, and tie loose threads of strip to secure gathers. Even out gathers and pin in place.

6. Stitch gathered piece to long piece, following baste stitch line.

7. Repeat steps 4-7 with another strip and opposite edge of long fabric piece. Repeat steps 4-7 again, placing the strip in the middle of the first two gathers. Lastly, repeat steps 4-7 again, placing last two strips in middle of edge and middle gathered strips.

8. Repeat steps 4-8 with other end of long fabric piece.
9. Pin long jersey knit pieces WRONG sides together, matching ends and sides. Raw edges should be visible after two pieces are stitched together.
10. Stitch 1/4″ from edge down length of pinned pieces on each side. When stitching near ruffles along sides, lift ruffles to the side and stitch underneath.

11. Stitch 1/4″ from edge along ends of pinned pieces, stitching over top of ruffles.

12. Try on your new scarf and go show it off! Great work!

Source: sewmuchado.blogspot.com