Featured Post

New Post

Popular Post

Crafty jewelry: MAGIC BRAIDED LEATHER TUTORIAL

Jewelry making, Other crafts  |  September 15th 2011  |  0 Comment

Seriously this tutorial is magic. I’ve been wanting to share it with you for about a year now, but it’s taken me so long to sit down & figure out the best way to explain myself. See, I discovered how to do this while mindlessly watching an episode of House.

My mother-in-law has a rad purse from the ’70s or so; it’s leather with a very cool handle. Parts of the handle are braided & parts are smooth. I thought it was just insanely cool how the handle was braided with closed ends!! What the . . . So I figured it out. Turns out it’s not as hard as you might think!

I’ll be sharing this today on KSL’s Studio 5! I’ll link to the video later today for further clarification. So click the link below to read the tutorial!

 

• M A G I C • B R A I D E D • L E A T H E R •

(of course the pattern pieces above aren’t the same, I was just too lazy to take a supplies pic that was practically the same as this one. hope you’ll forgive me.)

• S U P P L I E S •

  • hammer
  • scissors
  • hole punch
  • tape
  • button-stud/snap & setter
  • 1-2 oz leather/felt

Print and cut out pattern pieces. Tape onto leather. Carefully cut two inside slits with an X-acto knife & ruler. Punch holes then cut out perimeter of the pattern.

Tape your leather to a sturdy surface, like a desk or slab of wood. Start a tight braid with the farthest right strand & count each time you cross a strand.

Ignoring the bottom part as you go, count up to 6. Once you get to six, start untangling.

Look at the bottom part, the strand that’s on top should go through the hole. Follow the strand with the end of the bracelet.

Once you’ve followed through that end, your ends should look like this. Take the right strand & smooth it out. the end will want to go in between the right & middle strands. Once you’ve untangled that, start your second set of 6. You might need to untangle as you go as you run out of room. The bracelet pattern uses two sets of braids.

Once you’re done braiding, your bracelet will look a little lumpy. Don’t worry. Just give it some time & it’ll break in nicely.

Here are the photos animated so you get a better idea of how it goes.

Once you’re finished braiding, you’ll attach snaps or button-studs.

Wear on your wrist for a couple of days to break it in. Be sure to get it wet if you’d like for the braids to lie flat. ENJOY!!

Source: melissaesplin.com