beading bonsai tutorial

From the old receiver, has long been demolished and have broken one of the links telescopic antenki. The length of the tubes was 22 cm, diameter 5 mm.
Incidentally length was very comfortable, convenient measure such as length of wire left by the tip. 
At one end of the tube made drunk, ie propylaeum one of the walls of the tube to a length of about 5cm.
Turned out that’s such a magical duct.

 

If you do not have a hollow steel tube that you can use a wooden tube (eg ice-cream-popsicle) with nadpilom at one end.
With this tube making toys for Bones obtained in less than a minute. And now remains only to string beads on the wire, ie do low as possible dlinshe. Take the spool of wire and beads strung on wire, without cutting off from the coil.
Lowest applied to the tube, take the tube into the hands of kerf to themselves, leaving the free end of the wire from the cut, and low “outside”, ie pododvinuv the tip of the tube without cutting.

Thumb presses the wire to the tube next to the beads (beads rather moves at low direct to your finger), and low winds around the tube making 6.9 full speed, I normally do 7 or 8, for some reason I feel so comfortable.
Count’re in the process of winding, when wound right amount of complete revolutions extra beads marginalize low.

Then, holding his thumb turns our whole structure moves to the edge of the tube so that the coils were cut in the middle.

Remember that low we are not circumcised?
Take the free end of the wire, which we left early on, and pushes it into the propyl (see the arrows), and then pull out the tip of his leaning and firmly addictive.

Tube removed, it is we do not need (for the production of the ball)
When removing the tubes continue to hold the coils with beads, although they do not disintegrate, as tightened around the free end of the wire, just stick to the more convenient.
And push the wire end and the low turn down one side, stick to the side where the coil.

Then pretty much pull over push the wire end and tightening the loop while pulling all the coils wound in a pile

It remains only to twist kontsiki and cut low, pushing strung beads to the desired length.

Five minutes later, we already have a bunch of balls

A couple of days …

Two Trees …

This way you can do not only balls. If you make 9 turns, and place them sideways and then straightened around the stem then we obtain the original flowers. For example like in this bonsaychike:
Spring abundance

I hope our invention is useful to you.

 

source: i009.radikal.ru