ATTACHING LOCKS Beaded PRODUCTS TUTORIAL

For the manufacture of beads often (almost always) use the fittings.For fittings and include locks. Locks come in many different forms.

Longitudinal locks:
Coming out of the last bead products, recruit one more, pass through the handle of the lock and just typed beads back to the last bead products (Fig. 1 a). After this, we collect a bead on the other side of the product, we pass through the handle of the castle and return to typed beads in the last bead products (Fig. 1 b).

Thus, attach a lock in the plane of the product. The same scheme is necessary to pass 2 – 3 times to get a good secure lock. It is important to remember that the beads in the first and the last link of the product and bead fastening the lock should be chosen with the largest holes, because through them we are missing a needle several times.
Fig. Figure 2 shows the same attachment, but the difference is that the added bead lock before closing the skin.

Cross-locks:
These locks are mounted on a circle. Coming out of the last bead products, we collect a bead, go through the handle of the castle, recruit another bead and go through the last bead products (Fig. 3).

Figures 4, 5,6 shows the other commonly used types of fasteners.

“Shotgun” for necklaces

On both strands of a necklace strung on a single terminal on each side. Fasten the clamps at a distance of 1 cm from the edge.

Trace levels of strands necklaces – tighten or loosen as needed.

Strung Pearl (optional) bead, a bead on the knot and clip. The maximum time to move up the outer bead, which will hide the knot secure. Repeat the same with the other end. By arabino strung right, and a ring – on the left. Fix them with pliers. If necessary, trim the edges of threads. Drip some glue into the bead for the site and close it with pliers.

Loops and a variant Togla

Mounting Harness

One clue

source: img0.liveinternet.ru